9
Using
Using
–
Straight Cut (0°)
1. Attach the angle ruler (8) on the working
table and tighten with the locking screw.
2. Make sure the angle ruler is adjusted
to 0°.
3. Place the tile on the working table (1) and
move the sliding block over the tile (do not
cut the tile!)
4. If necessary, fold out the side arms (14) in
order to securely position a long tile.
5. Make sure the cutting edge of the cutting
wheel matches the marking on the tile.
6. Hold the tile with one hand and move the
sliding block with the cutting wheel across
the tile.
7. According to the thickness of the tile, use
the correct breaking foot (6 or 7). For tiles
with a thickness smaller than 10 mm, use
the small breaking foot (6) and for thick
tiles, use the large breaking foot (7).
