Westfalia 81 81 61, Инструкция по эксплуатации

Страница: 18 / 23

13
Operating
2. Insert the drill/screw bit all the way in and then turn the chuck clockwise
hand tight. This will automatically lock the drill chuck.
3. To release the locking and to remove the tool, turn the chuck counter
clockwise.
Adjusting the Torque
1. With the torque setting ring (2) you can set up the maximum torque. The
higher the number on the setting ring, the higher the selected torque will
be.
2. When starting to work, set the torque to a low value. When the set torque
is reached, the clutch is released and the work piece can not be damaged.
3. When the torque setting ring is set to the drill symbol, the clutch is locked
and can not slip.
Setting up the Gear
1. This cordless drill is equipped with a two gear
transmission. With the gear switch (12) on top
of the machine you can change between both
gears.
2. Use the high speed ( HIGH ) for drilling and the
lower speed (
LOW
) for driving screws.
Note: Only operate the gear switch when the motor has halted completely.
Drilling
ƒ At the start of drilling select a lower speed to avoid the drill bit slipping
away from the desired hole location.
ƒ If the drill-hole is deep, the drill-bit may become jammed in the hole. In this
case a high torque could damage the drill bit or the drill. If the bit becomes
jammed, hold the machine firmly and immediately release the On/Off
trigger. Switch to counter clockwise rotation and use a low rotation speed
to remove the jammed drill bit more easily.
Screwing
ƒ Before using the machine check whether the screw bit is inserted
correctly. Avoid over-tightening, otherwise the screw head may be
damaged or stripping of the threads may occur.
ƒ Use the rotating direction button (4) to set up the rotion in clockwise
12