Westfalia 1050 W RS 1050, Оригинальное руководство пользователя

Страница: 22 / 30

18
Operation
Operating

The reciprocating is intended for two-
handed operation only. When working,
always hold the reciprocating saw as
shown in the figure on the right with
both hands only.

Never reach your hands over the
blade clamp or the pivoting shoe (2).
There is risk of injuries!

Fasten the workpiece to be processed in a suitable vice before cutting. If
possible, remove any foreign bodies such as nails, screws etc. or make sure
not to cut the foreign bodies with a saw blade that is not suitable for this work.
1. Insert the power plug into the wall socket.
2. To switch ON the reciprocating
saw, press and hold the ON/OFF
trigger (9). To switch off the
reciprocating saw release the
ON/OFF trigger.
First, allow the saw blade to run
and then bring the pivoting shoe
(2) into contact with the surface of
the workpiece. Only use low pressure when
operating the reciprocating saw. Do not start
cutting if the saw blade is inside the workpiece or
contacts the surface of an object. There is danger
of serious injury or damages.
The saw blade should not be longer than required
for the intended cut. A 4 cm longer saw blade will
avoid excessive kickback.
3. To switch off the reciprocating saw, unlock the
ON/OFF trigger and wait until the saw has come to a standstill. Now you can
remove the saw blade from the workpiece.
4 cm
Saw Blade too short