8
Form No. 13629
September 1,1999
Assembling Light Brackets and Headlamps
NOTE: Lights may be positioned lower than the
hole locations allow. Using the existing holes as
a guide for the top light bracket, position the
lights where preferred. Using the existing light
bracket holes as a guide, drill 3/8” diameter
holes through the lift frame and attach brackets
with provided 3/8” x 1-1/4” bolt and locknuts.
Two options for headlamp mounting height are
available through 5 holes in the lift frame side angles.
The difference in height between the two positions is
3-3/16’’. Sport/Utility blades normally use the lower
mounting holes.
1. Align two holes of two top light brackets with the
second and third holes in lift frame side angles.
Loosely attach with two 3/8’’ x 1-1/4" bolts and
locknuts on each side.
2. Loosely attach the small hole end of the two
bottom light brackets to the lowest hole in each lift
frame side angle with a 3/8’’ x 1-1/4’’ bolt and
locknut on each side.
ASSEMBLY INSTRUCTIONS
3. Assemble headlamps (found in headlamp kit) to
the light brackets, placing the headlamp swivel
above the bracket. Loosely attach with lock
washers and nuts below the brackets.
Aim headlamps when plow is attached to vehicle.
4. Tighten bolts holding light brackets to lift frame.
5. Install vinyl caps on headlamp mounting studs.
CAUTION
Do not position or align lights so that the beam
is blocked by the raised blade
Bottom
Light
Bracket
Top Light Bracket
Lift Frame
Side Angle
3/8" x 1-1/4"
Bolts &
Locknuts
Use 2nd,
3rd, and
bottom
holes
Figure 6
Light Bracket Installation
