Lit. No. 43572/43582/43592, Rev. 02
14
January 1, 2017
STARTING AND STOPPING MOTOR
1. To start the spreader, press the
POWER switch to ON position on the control.
2. Press the POWER switch to the OFF position to
stop the spreader. Speed of auger and spinner
may be adjusted separately to get desired flow
and spread distance.
NOTE: The truck ignition must be ON to start the
spreader.
NOTE: If truck ignition is turned OFF while
spreader is running, the motors will stop.
Vibrate
ON/OFF
Switch
Spinner Speed
Dial
Power ON/OFF
Switch
Auger
Speed Dial
ADJUSTING AUGER/SPINNER SPEED
1. Turn speed dial clockwise to increase speed.
When POWER switch is set to ON position, the
spreader will accelerate to speed set on spinner
and auger dials.
2. Turning speed dial counterclockwise will decrease
speed.
NOTE: Always use the tarp kit on the hopper to
prevent moisture buildup. Do not let spreader sit
idle with material in the hopper for an extended
period of time. This can cause material to
compact, reduce or stop the flow of material and
cause permanent hopper body deformation.
NOTE: The vibrator switch is needed for dense
material or to increase the flow to the auger. This
eliminates bridging of material in hopper.
NOTE: A material baffle has been installed in your
spreader to stop fine material from free flowing.
If using dense or damp material, or if more flow
is desired, remove material baffle. However, it is
recommended that the material baffle remain in
place if using bulk salt.
WARNING
Never operate equipment when under the
influence of alcohol, drugs, or medications
that might alter your judgment and/or reaction
time.
WARNING
Never allow children to operate or climb on
equipment.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
OPERATING THE SPREADER – CAB CONTROL