Lit. No. 43071, Rev. 05
6
December 15, 2016
INSTALLATION INSTRUCTIONS
Pivot Bar to Pivot Plates
1. Position the T-frame and pivot bar between the
pivot plates, aligning the hole at each end of the
pivot bar with the appropriate hole in the pivot
plate as determined by distance "d."
2. On each side, insert 1" x 4-3/4" clevis pins from
the inside of the pivot bar through the correct pivot
plate holes. Secure the clevis pins with 1" flat
washers and 1/4" x 1-1/2" cotter pins.
1" x 4-3/4"
Clevis Pin
1" Flat
Washer
1/4 x 1-1/2"
Cotter
Pivot Plates
Pivot Bar
STAND SHOE
Initial stand shoe height adjustment is based on
the receiver height measurement (distance "d")
determined in Step 1 under "Pivot Plate Hole Position."
A final adjustment of the stand shoe will be made after
attaching the snowplow to the vehicle.
1. Slide the stand shoe into the stand tube and align
the 1/4" hole in the stand tube with the 1/4" hole in
the stand shoe as determined from the chart and
illustration below.
Stand Shoe Position Chart
Distance "d"
Position
13.0" – 14.5"
1
14.5" – 16.0"
2
16.0" – 17.5"
3
17.5" – 19.0"
4
2. Insert a 1/4" roll pin.
3.
Do not cut the spring tie until after the final stand
shoe adjustment.
Position 1
Position 2
Position 3
Spring Tie
Position 4
1/4" Roll Pin
WARNING
The stand plunger spring is shipped
compressed and tied. Do not cut the spring
tie until final stand shoe adjustment is
complete and the roll pin is installed.
