Westermo ODW-710-F1, Руководство пользователя

Страница: 16 / 24

16 6651-2201
Start up guide
Follow the steps below to get the unit up and running in a simple application.
… Use the factory DIP-switch settings.
… Connect The fibre link between the both units.
… Connect the power supply to both units.
The Fibre link should be in operation as indicated by the CH1 LED.
… Connect the PROFIBUS DP connectors between both ODW-710-F1 and PROFIBUS
units configured to be units in the PROFIBUS DP network. The PROFIBUS DP will be
in operation and the data rate will be automatically detected, as indicated by the BA
LED.
… The point to point application is up and running.
Note: In an ODW-710-F1 fibre optic link there will be some additional processing
delays that do not exist in an electrical bus. It is possible that the PROFIBUS
application must be adjusted to accommodate for this delay. See “Calculating
system processing delay” for more information on how to determine the overall
system delay time.
POWER CH 1
COM +VA +VB COM
POWER CH 1
COM +VA +VB COM TX RX TX RX
PROFIBUS DP master
Fibre Optic
PROFIBUS DP PROFIBUS DP
PROFIBUS DP slave