Westermo Lynx SERIES, Руководство пользователя

Страница: 21 / 28

Ethernet TX
Electrical specification IEEE std 802.3
Data rate 10 Mbit/s, 100 Mbit/s, manual or auto
Duplex Full or half, manual or auto
Circuit type TNV-1
Transmission range Up to 150 m with CAT5e cable or better
Isolation All other ports
Connection RJ-45, auto MDI/MDI-X
Cabling Shielded CAT5e or better is recommended
Shielded cable Not required, except when installed in railway application as signalling and
telecommunications apparatus and located close to rails
a
Conductive chassis Yes
Number of ports 4
a
To minimise the risk of interference, a shielded cable is recommended when the cable is located inside 3 m
boundary or the cable is longer than 30 m and inside 10 m boundary to the rails and connected to this port.
Ethernet SFP pluggable connections (FX or TX)
Electrical specification IEEE std 802.3
Data rate 100 Mbit/s, 1000 Mbit/s, transceivers supported
Duplex Full or Auto, depending on transceiver
Transmission range Depending on transceiver, see datasheet for SFP transceivers
Connection SFP slot holding fibre transceiver or copper transceiver
Number of ports 1 or 2
I/O connection, Relay output
Maximum voltage/current 60 VDC/80 mA
Connect resistance Maximum 30 Ω
Isolation To all other ports
Connector Detachable screw terminal
Conductor cross section 0.14 - 1.5 mm² (AWG 28 - 16)
Stripping length cable 7 mm
Tightening torque, terminal
screw 0.22 - 0.25 Nm
Tightening torque, screw
flange 0.3 Nm
Lynx L106/206-F2G 21