14
6623-2231
Getting started
Default Network Settings
IP address (Ethernet ports)
192.168.2.200
Netmask (Ethernet ports)
255.255.255.0
Username
admin
Password
westermo
Power Supply
The ADSL-350 requires a DC power source in the voltage range of 10 to 60 VDC.
The unit is designed to self protect from permanent damage if the voltage exceeds
60 VDC or if reverse polarity is applied. The router may need to be returned for service
if this occurs. The router can also be damaged if there is any potential difference between
the chassis-ground, RS-232 signal ground, power (–) input, or antenna shield.
Before connecting any wiring, ensure all components are earthed to a common ground
point. An external isolator will be required if a positive earth power supply is used.
Step-by-step guide
to configure an ADSL-connection using the web-interface
Step 1 – Power-up the unit and wait for it to become ready
Connect the ADSL-350 to the DSL-network using the RJ-11. Then connect an RJ-45 cable
from one of the two Ethernet-ports to your PC, and finally connect the unit to an appro-
priate PSU and power it up. As soon as the STS LED is lit GREEN the unit is ready to be
configured, it should take about 30 seconds.
ADSL
connection (RJ-11)
Power Connection
PC/Ethernet
connection (RJ-45)
