Page
25
of
54
Commissioning
9
Commissioning
To commission the hand-operated power sweeper, it is moved from its standby
position to the working position.
9.1
Adjusting the handle height
A handle height adjustment serves to set the height of the handle without the
help of any tools. This allows the handle height to be ergonomically adjusted for
different body sizes in short time.
Adjustment procedure
Fig. 5 - Handle height
Unlock the locking bolt on both sides as shown
in the illustration.
Swivel the handle to the desired working
position.
Properly relock the locking bolt in the bore
pattern.
9.2
Adjusting the axle height
Depending on the degree of wear of the braided wires, the adjustable axle of the
machine must be readjusted. The horizontal alignment ensures the clean and
even wear of the wire brush braids.
Fig. 6 - Axle adjustment
Unlock the locking bolt on both sides as shown
in the illustration.
Raise or lower the machine to the desired
position.
Observe the horizontal alignment of the
machine.
Properly relock the locking bolt in the bore
pattern.
