Section BXM‐301‐10H‐20A
030‐101901 Rev. A
R
9
1608IARA
Figure 14. H‐Frame Mounting
H‐frame Sliding Nut
(compress spring
and slide nut into
ends of rails)
Bolt
Washer
Pole or
post
H‐frame Rail
or Channel
DETAIL A
H‐frame Sliding Nut
(slide nut into end of
rail, see DETAIL A)
62.6"
Top and bottom mounting
brackets from mounting kit
shown attached
Distance between
mounting holes
ÖÖ
ÖÖ
ÖÖ
ÖÖ
ÖÖ
5.
Attach cabinet to H‐frame rails.
Align the holes in the cabi
net's top mounting bracket with the holes in the inserted
rail nuts in the H‐frame rails, then insert and install an ap
propriate H‐frame mounting bolt through each set of
aligned holes. Westell recommends a minimum of 3
mounting bolts per mounting bracket (top and bottom).
Tighten hardware appropriately. Repeat for the bottom
mounting bracket and H‐frame rail. Verify the cabinet is
in the proper horizontal position, make any needed ad
justments, then securely tighten all mounting hardware.
6.
Test installation firmness.
Test the installation by attempt
ing to move the cabinet. Correct any looseness, if
detected. Tighten all bolts again.
7.
Determine next step.
If ground, power, and communica
tions cables and internal equipment will not be connected
and mounted at this time, proceed to the next step to final
ize the cabinet installation. If ground, power, and
communications cables and internal equipment will be
connected, mounted, and powered‐up at this time, skip
the next step and proceed to Paragraphs 3.7 through Para
graph 3.16 for those procedures.
8.
Close up cabinet and clean the site.
Close the Boxer‐30
door, and lock it using a can wrench or 216 tool and an op
tional padlock. Pick up any tools and materials at the
installation site, and clean the site of any trash or debris.
