Westeel WaterTank Flat Roof, Инструкции по установке и хранению

Страница: 8 / 23

Assembling Westeel Flat Roof System
1. Assemble top ring of wall sheets as per wall sheet layout provided with water tank.
2 a. Install 90° ring angle around the top perimeter of the tank such that the leg is out.
b. Apply sealant tape around the edge of the diameter of the 90° ring angle.
3 Make sure tank is round before
installing roof, this will affect
assembly and future performance.
4 Consult the layout of the “Z” rafters
to determine the distance between
the bolt hole locations along the top
edge of adjacent rafters and for the
orientation of the rafters…not all
rafters are assembled in the same
orientation.
5. Assemble the attachment brackets to the each end of the “Z” rafters
as shown. Make sure the tabs on the brackets are positioned on the
top side (i.e. the side with holes evenly spaced at 44”). Note that
there are right and left attachment brackets. Snug up the nuts but
leave loose enough in the slots so that future adjustment is possible.
BOTTOM RING ANGLE
- SECURED WITH 3/8 x 1"
FLANGE BOLT
RAFTER BRACKET
199743L (SHOWN)
& 199743R
RAFTER
WALLSHEET
OUTSIDE
ANGLE
Page 8