Page
8
of
14
Use a wire cutter to remove the ears from
both sides of the elevator servo.
Glue the plywood elevator horn into the
slot provided as shown in the picture.
Glue the elevator servo in the hole
provided with the arm centered straight
up.
Attach the wire Z bend to the plywood
horn and EZ connect as shown in picture.
I recommend using the center hole on the
plywood elevator horn.
The elevator servo wire can be glued to
the inside of the tail boom with CA or hot
melt glue.
Cut a slit (red arrow in picture) part way
into the underside of the wing and insert
elevator wire, this is done to hide the
servo wire and decrease drag.
