• Never place light face down when light is on or is still hot from recent use. Doing so could burn/ignite surfaces such as
carpeting, etc. and cause major property damage. Always turn light off and unplug from power source when not in use.
• To prevent serious damage to eyesight, never look into light when light is on. Do not shine light into the face of others.
• Do not touch lens of light when light is on or if it was recently on. The lens will be hot and could cause serious burns.
• Keep battery clips or DC plug dry and out of water at all times. Dry location use only.
• Do not place light in water.
• Do not allow children to handle or operate this light.
• Do not use this product for other than its intended use.
• Do not operate in close proximity of combustible or flammable materials.
• Do not attempt to operate light if cord, plug, bulb or any part of the light is damaged or corroded.
USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR LIGHT.
FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL
COULD RESULT IN BODILY INJURY OR PROPERTY DAMAGE.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
IMPORTANT SAFETY WARNINGS
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL
BEFORE OPERATING LIGHT.
WARNING
•
Never attempt to wipe or clean the inner reflective surface of the
reflector. Touching or wiping the surface will damage it permanently.
•
The lens is made of optical-quality, tempered glass. As with all glass,
avoid dropping or sharp impact on light.
•
Do not allow the hot lens to come in contact with water or materials
subject to heat damage.
•
This light is not waterproof. Do not use the light under water or store
outdoors.
•
Only use a 12-volt, halogen bulb that is designed for your
light. Use of any other bulb may result in poor performance
and may damage your light.
•
After months of use, DC receptacles can build up corrosion that may
prevent your light from making good contact. It may be
necessary to clean the inside of your DC receptacle with a fine emery
cloth. Before cleaning receptacle, remove the fuse to prevent it from
shorting out.
Tips to Avoid Damage to
Your Light
1
