6
7
8
13
6. Attach the Seat (12) to the Seat Frame (3) with four
M6 x 16mm Zinc Screws (57).
6
7. The Console (16) requires two AA batteries (not includ-
ed). Alkaline batteries are recommended. Refer to the
inset drawing. Remove the battery cover from the back
of the Console, and insert two AA batteries into the
Console. Make sure that the negative ends of the
batteries (marked “–”) are touching the springs in
the Console. Reattach the battery cover.
Next, plug the Reed Switch Wire (43) into the back of
the Console (16). Carefully slide the Console onto the
indicated tab on the Frame (1). Note: The Console is
held by friction; it does not snap into place.
Press the Resistance Knob (14) onto the Resistance
Control (13).
8. Identify the Left Pedal (24), which is marked with an
“L.” Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the left arm of the
Crank (27). Tighten the Right Pedal (26) clockwise into
the right arm of the Crank. Important: Tighten both
Pedals as firmly as possible. After using the
crosstrainer for one week, retighten the Pedals. For
best performance, the Pedals must be kept tight-
ened.
Refer to HOW TO ADJUST THE PEDAL STRAPS on
page 7 and adjust the Left Pedal Strap (65) to the
desired position. Adjust the Right Pedal Strap (66) in
the same way.
16
12
3
57
57
1
43
14
16
24
27
26
66
65
Battery
Cover
9. Make sure that all parts of the crosstrainer are properly tightened. Note: Some hardware may be left
over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
crosstrainer.
Batteries
