Inspect and tighten all parts of the AIR STRIDER reg-
ularly. Replace any worn parts immediately. The AIR
STRIDER can be cleaned with a soft, damp cloth.
Keep liquids away from the electronic monitor. Keep
the monitor out of direct sunlight or the display may
be damaged. Remove the batteries when storing the
AIR STRIDER.
HOW TO FOLD THE AIR STRIDER FOR STORAGE
When the AIR STRIDER is not in use, it can be folded
for compact storage. To fold the AIR STRIDER, first
remove the lock knob and lock washer from the right
leg. Next, hold the resistance dials and fold the frame
and the uprights together.
Place the AIR STRIDER in
a location where it cannot fall.
REPLACING THE BATTERIES
If the display of the electronic monitor becomes dim,
or if the monitor does not function properly, the batter-
ies should be replaced. To replace the batteries, refer
to assembly step 6 on page 6.
HOW TO ADJUST THE REED SWITCH
If the speed and distance modes do not display cor-
rect information, the reed switch should be adjusted.
The reed switch is
located below the
electronic monitor
(see the drawing at
the right). Loosen the
screw in the reed
switch, move the reed
switch to the side
slightly, and retighten
the screw.
Make sure
that the reed switch
does not hit the
indicated magnet when the AIR STRIDER is in
use.
Repeat until the speed and distance modes
display correct information.
8
OPERATING THE ELECTRONIC MONITOR
1. To turn on the power, press the on/reset button or
simply begin exercising on the AIR STRIDER. The
entire display will appear for two seconds. The
electronic monitor will then be ready for operation.
2. Select one of the five modes:
Scan mode
ÑWhen the power is turned on, the
scan mode will be selected automatically. The
scan mode can also be selected by repeatedly
pressing the mode button. One mode indicator will
show that the scan mode has been selected, and
a second mode indicator will show which mode is
currently displayed.
Speed, time, distance, or calories mode
Ñ
These modes can be individually selected by
repeatedly pressing the mode button. The mode
indicators will show which mode has been select-
ed. (Make sure that the scan mode is not select-
ed.) The modes will be selected in the following
order: speed, time, distance, calories, scan.
3.
The monitor has an auto-off feature to turn off
the power.
If the pedals are not moved and the
monitor buttons are not pressed for four minutes,
the power will turn off automatically in order to
conserve the batteries.
To reset the LCD display, press the on/reset button.
STORAGE AND TROUBLE-SHOOTING
Reed
Switch
Magnet
Frame
Upright
Resistance
Knob
Lock
Knob
Lock
Washer
