4
ASSEMBLY
Assembly requires two persons.
Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner , Phillips screw-
driver , and pliers .
As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST on page 14. The number following the
parentheses is the quantity needed for assembly.
Note: Some small parts shown in the assembly steps may
be preassembled. If a part is not found in the parts bag, check to see if it has been preassembled.
M10 Nylon Locknut
(44)–4
M8 x 15mm Button
Screw (51)–4
M5 x 12mm
Screw (52)–2
M5 x 54mm Button
Screw (48)–1
M8 Nylon
Locknut (46)–3
M8 x 1.2mm
Washer (53)–3
M10 x 1.5mm
Washer (54)–4
M8 Curved
Washer (50)–4
M5 Curved
Washer (49)–1
M10 x 70mm Carriage Bolt (16)–4
Acorn Cover (35)–4
1. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (7) to the Frame with two
M10 x 70mm Carriage Bolts (16), two M10 x 1.5mm
Washers (54), and two M10 Nylon Locknuts (44).
Next, press two Acorn Covers (35) onto the Nylon
Locknuts.
1
44
44
35
16
35
7
54
54
1
