7
2. Remove the screw (not shown) and the card-
board tube (not shown) from the Frame (1) if
necessary. Discard the screw and the cardboard
tube.
Orient the Front Stabilizer (2) so that the large
holes face the Frame (1).
Attach the Front Stabilizer (2) to the Frame (1)
with two M10 x 70mm Screws (33).
1
2
33
2
Large
Holes
3
3. While a second person holds the Upright (13)
near the Frame (1), connect the Extension Wire
(23) to the Reed Switch Wire (39).
Next, connect the Resistance Cable (19) to the
Lower Resistance Cable (29) in the following
way:
• See drawing A. Pull upward on the metal
bracket on the Lower Resistance Cable (29),
and insert the tip of the Resistance Cable (19)
into the wire clip inside the metal bracket.
• See drawing B. Firmly pull the Resistance
Cable (19) upward and slide it into the top of
the metal bracket.
• See drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Insert the wires and cables into the Frame (1).
Tip: Avoid pinching the wires and cables.
Insert the Upright (13) into the Frame (1).
Attach the Upright (13) with three M8 x 15mm
Screws (34) and three M8 Split Washers (50).
Avoid pinching the
wires and cables
39
19
29
34 50
50
23
13
1
34
A
B
C
29
19
19
Metal
Bracket
