6
4. The Console (7) requires one AA battery (not
included); an alkaline battery is recommended.
See the inset drawing.
Remove the battery
door from the back of the Console, and insert
a battery into the Console.
Make sure that the
battery is oriented as shown by the diagram
inside the console.
Then, reattach the battery
door.
Next, plug the Reed Switch Wire (28) fully into
the socket on the back of the Console (7).
Then, slide the Console (7) onto the console
plate. Note: The Console is held by friction; it will
not snap into place.
Battery Door
Battery
7
7
28
Console
Plate
4
3. Remove all parts from the Pivot Axle (3).
Apply a generous amount of the included grease
to the Pivot Axle (3).
Insert the Pivot Axle (3) into the Frame (1), and
align the hole in the center of the Pivot Axle with
the hole in the center of the Frame. Then, tighten
an M5 x 16mm Machine Screw (32) into the
Frame and the Pivot Axle.
Slide the Left and Right Handlebars (40, 41) onto
the ends of the Pivot Axle (3). Next, slide an M8
Flat Washer (38) onto each end of the Pivot Axle,
and tighten an M8 Locknut (9) onto each end
of the Pivot Axle.
Make sure that at least two
threads on each end of the Pivot Axle extend
past each Locknut.
In addition, make sure
that the Handlebars move freely
.
Next, press a Pivot Cap (50) onto each end of
the Pivot Axle (3).
40
1
32 Hole
38 9
41
3
50
9
38
Grease
50
3
