16
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Per FCC rules, changes or modifications not expressly approved by ICON could void the
user's authority to operate the equipment.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
drive belt may need to be adjusted. To adjust the drive
belt, the pedals and the shields must be removed.
Use an adjustable wrench to remove the pedals. To
remove the left pedal, turn the left pedal clockwise; to
remove the right pedal, turn the right pedal counter-
clockwise.
Next, remove all of the screws from both shields;
there are two sizes of screws in the shields—note
which size of screw you remove from each hole.
Then, carefully remove the shields.
Loosen the 3/8" Nut (27) and the Flywheel Nut (43),
which are located on each side of the Flywheel (37).
Then, tighten the M6 Locknuts (32), one on each side
of the Flywheel, until the Drive Belt (35) is properly
tightened.
Finally, tighten the 3/8" Nut (27) and the Flywheel Nut
(43) and reattach the shields and the pedals.
35
37
43
32
27
