HOW TO ADJUST THE BELT
The exercise cycle features a precision belt that must
be kept properly adjusted. If the belt causes exces-
sive noise or slips as you pedal, the belt should be
checked. To do this, the left side shield must first be
removed. Refer to the instructions on page 12 and
remove the left side shield. Next, use an adjustable
wrench to turn the right pedal counterclockwise and
remove it. Then, remove the right side shield.
Press down on the center of the Belt (16) between the
front and rear pulleys (see the drawing at the right).
There should be from 1/4” to 1/2” of vertical
movement in the center of the Belt. If the Belt is
properly adjusted, reattach the side shields and the
pedals. If the Belt needs to be adjusted, loosen the M8
Nylon Locknut
(21) on each
side of the
Flywheel (32).
To tighten the
Belt, turn the
two indicated
M6 Stop Nuts
(47) clockwise;
to loosen the
belt, turn the
Stop Nuts coun-
terclockwise. Make sure that the Flywheel is straight
and retighten the M8 Nylon Locknuts (21). When the
belt is properly adjusted, reattach the side shields and
the pedals.
13
16
32
21
47