Weslo DX10, Руководство пользователя

Страница: 9 / 23

9
Clip
Pulse Sensor
Key
Speed Control
Displays
DIAGRAM OF THE CONSOLE
On/Reset Button
BATTERY INSTALLATION
The console requires three "AA" batteries (not includ-
ed); alkaline batteries are recommended. Open the
battery cover and press the batteries into the console;
the negative (–) ends of the batteries must touch the
springs. Close the battery cover, push up on the tab,
and then push the tab forward as shown in the inset
drawing. Be sure that the tab locks into place.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 8.) In addition,
make sure that batteries are installed in the console. If
there is a thin sheet of clear plastic on the console,
remove it.
Step onto the foot rails of the treadmill. Next, find the
clip attached to the key (see the drawing above). Slide
the clip onto your waistband.
Follow the steps below and on page 10 to operate the
console.
Insert the key fully into the power switch.
Note: Inserting the key
will not turn on the dis-
plays. The displays will
turn on when the dis-
play on/reset button is
pressed or when the
walking belt is started.
If you just installed bat-
teries, the displays will
already be on.
1
CAUTION:
Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
Battery Cover Tab
Batteries
Battery
Cover