6. Attach the Storage Latch (12) to the left Upright (14) with
two Screws (55). Do not overtighten the Screws.
Tighten all of the bolts used in steps 3 and 4.
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
safe place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
55
12
14
6
4. Attach the lower end of the Right Handrail (57) to the
Extension Leg (41) with a Handrail Bolt (59), a Handrail
Washer (32), and a Handrail Nut (82) as shown. Do not
tighten the Handrail Bolt yet. Note: It may be neces-
sary to push on the lower end of the Handrail to align the
hole in the Handrail with the hole in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described in steps 3 and 4. Note: There is not
a wire harness in the left Upright.
4
32
59
82
41
57
5. Place the Console Base (6) on the Handrails (2, 57).
Connect the two Wires (26) to the connectors in the
Console Base. Important: Make sure that the Wires
are fully inserted. WARNING: Do not disconnect or
connect the Wires while the treadmill power cord is
plugged in.
Thread four Screws (55) into the Handrails (2, 57) and
the Console Base (6). After all four Screws have been
started, tighten the Screws until they are snug; do
not overtighten the Screws.
55
26
Connectors
6
2
57
5
6
3. Refer to drawing 3a. If there is a plastic tie in the Cage
Nut (3) in the Right Handrail (57), remove the plastic tie.
Pull 6” of the Wire Harness (26) out of the Right Upright
(14). Route the Wire Harness up through the bracket on
the Right Handrail and out of the upper end as shown. (If
necessary, use needle-nose pliers to grip the end of the
Wire Harness.) Thread the included plastic tie through
the indicated holes in the Right Handrail.
Refer to drawing 3b. Look into the Right Handrail (57)
and make sure that the Wire Harness (26) is on the indi-
cated side of the plastic tie. Then, tighten the plastic tie
and cut off the end.
Refer to drawing 3c. Insert the bracket on the Right
Handrail (57) into the right Upright (14), with the lower
end of the Right Handrail beside the Extension Leg (41).
Hand tighten a Short Handrail Bolt (15) with a Washer
(16) into the upper end of the Upright.
14
16
15
41
57
3c
26
57
3
14
Tie
3a
3b
26
57
Tie
