8
DIAGRAM OF THE CONSOLE
Clip
Key
Pulse Sensor
Incline Control
Speed Control
Monitor Display
BATTERY INSTALLATION
The console requires
two "AA" batteries
(not in-
cluded). Alkaline batteries are recommended. To in-
stall batteries, first
touch the Handrail (2) to dis-
charge any static.
Next, open the battery cover as
shown below. Press two batteries into the battery com-
partment, with the negative (Ð) ends of the batteries
touching the springs. Close the battery cover, push up
on the tab, and then push the tab forward as shown.
Be sure that the tab locks into place.
STEP BY STEP CONSOLE OPERATION
Step onto the foot rails of the treadmill. Find the clip
attached to the key (see the drawing above), and slide
the clip onto the waistband of your clothing. Follow the
steps below and on page 9 to operate the console.
Insert the key fully into the power switch.
Note: Inserting the key
will not turn on the dis-
plays. The displays will
turn on when the
ON/RESET button is
pressed or when the
walking belt is started.
(If you just installed
batteries, the displays will already be on.)
1
Batteries
2
Battery Cover
Battery
Cover Tab
CAUTION:
Before operating the
console, read the following precautions.
¥ Do not stand on the walking belt when turning
on the power.
¥ Always wear the clip (see the drawing above)
while operating the treadmill. When the key is
removed from the console, the walking belt will
stop.
¥ Adjust the speed in small increments.
¥ The training zones marked around the speed
control are general guidelines only. See page
14 or more information.
¥ To reduce the possibility of electric shock, keep
the console dry. Avoid spilling liquids on the
console and use only a sealable water bottle.
