Weslo Cadence Cr12 Treadmill, Руководство пользователя

Страница: 9 / 22

9
9. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included allen wrenches in a secure place for adjustment purposes (see page 16). To protect the floor or
carpet, place a mat under the treadmill.
8. Press the Latch Knob Sleeve (73) into the Left Upright
(14). Remove the Latch Knob (54) from the Latch Pin
(66). Make sure that the Latch Pin Collar (56) and the
Spring (55) are on the Latch Pin, and insert the Latch
Pin into the Latch Knob Sleeve from the side shown.
Tighten the Latch Knob back onto the Latch Pin.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 13). Make sure
that the frame is centered between the two Handrails
(4). Firmly tighten all of the bolts and screws used in
steps 2, 3, and 4. Then, lower the frame to the floor.
73
14
4
54
56
55
66
8
87
31
53
12
5
4
5
5
7
7. Set the Console (11) in the Console Base (87). Make
sure that no wires are pinched or obstructing the
area under the Battery Cover (12). Insert as much of
the Wire Harness (53) as possible down into the hole in
the right Handrail (4). Securely tighten the plastic tie
nearest to the right Handrail. Pull any excess Wire
Harness from between the plastic ties, and then tighten
the second plastic tie. Cut off the ends of both plastic
ties. Cover the Wire Harness with the Wire Cover (31),
and route the Wire Harness out of the hole in the side of
the Wire Cover. Attach the Wire Cover to the back of the
Console Base with two 3/4” Screws (5). Do not over-
tighten the Screws.
Make sure that no wires are pinched. Attach the
Console (11) to the Console Base (87) with the four
remaining 3/4” Screws (5). Do not overtighten the
Screws.
11
Ties