1. With the help of a second person, carefully lay the
treadmill on its side. Position one of the Base Legs
(55) on the base of the Upright (37) as shown. Make
sure that the Base Leg Pads (31) and the Wheel (34)
are in the indicated positions. Attach the Base Leg
with two of the four Base Leg Bolts (28), Base Leg
Washers (68), and Base Leg Nuts (61).
Carefully turn the treadmill onto its other side.
Assemble the other Base Leg (55) as described
above.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base Legs (55)
are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow step 2 on page 11 to lower the
treadmill.
Next, attach the Left Frame Guide (66) and the Frame
Guide Spacer (46) to the left side of the Frame (21)
with four Screws (25). Note: Be careful not to over-
tighten the Screws. Make sure that the thick end of
the Left Frame Guide is at the bottom.
1
5
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• The underside of the treadmill walking belt is
coated with high-performance lubricant. During
shipping, a small amount of lubricant may be
transferred to the top of the walking belt or the
shipping carton. This is a normal condition. If
there is lubricant on top of the walking belt, wipe
off the lubricant with a soft cloth and a mild, non-
abrasive cleaner.
• The console and the right handrail are connected
to the treadmill by the wire harness. (See assem-
bly step 3.) During steps 1 and 2, be careful to
avoid damaging the wire harness.
• As you assemble the treadmill, be sure that all
parts are oriented as shown in the drawings.
The following tools (not included) are required
for assembly:
• Two (2) adjustable spanners
• One (1) phillips screwdriver
28
68
31
55
34
37
61
2
21
66
46
Thick end
25
