6
15
ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials;
do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the hex key and your own phillips screwdriver , two
spanners , and wire cutters .
Note: To identify small parts used during assembly, see the PART IDENTIFICATION CHART in the center of
this manual. Some parts may be preassembled.
1. Have a second person hold the Base (54) in the position
shown.
Identify the Left Upright (55) (the Right Upright [56] has a
large hole near the lower end).
Hold the Left Upright (55) so the bend is in the posi-
tion shown. Insert two Upright Bolts (2) into the
bracket on the Left Upright.
Attach the Left Upright to
the Base (54) with the Upright Bolts and two Upright Nuts
(16).
Do not tighten the Upright Nuts yet.
Attach the Right Upright (56) to the Base (54) in the same
way.
2. Slide the two Wheel Housings (64) onto the Base (54).
Attach each Wheel Housing with two Wheel Housing Bolts
(6), two Wheel Housing Washers (11), and two Wheel
Housing Nuts (15).
54
55
56
16
1
2
2
16
2
54
Large
Hole
6
11
64
15
11
6
64
15
Bend
HOW TO FOLD AND MOVE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
Unplug the power cord. CAUTION: You must be able to
safely lift 20 kg (45 lbs.) to raise, lower, or move the
treadmill.
1.
Hold the metal frame firmly in the location shown by
the arrow at the right. CAUTION: To decrease the pos-
sibility of injury, do not lift the frame by the plastic
foot rails. Make sure to bend your legs and keep your
back straight. As you raise the frame, make sure to lift
with your legs rather than your back.
Raise the frame
about halfway to the vertical position.
2. Move your right hand to the position shown and hold the
treadmill firmly. Using your left hand, pull the latch knob
to the left and hold it. Raise the frame until the catch is
past the latch pin. Then, slowly release the latch knob;
make sure that the latch pin is resting against the
catch.
To protect the floor or carpet from damage, place a
mat under the treadmill. Keep the treadmill out of di-
rect sunlight. Do not leave the treadmill in the stor-
age position in temperatures above 30°C (85°F).
HOW TO MOVE THE TREADMILL
Before moving the treadmill, convert the treadmill to the stor-
age position as described above.
Make sure that the latch
pin is fully inserted into the catch.
1. Hold the handrails and place one foot against one of the
wheels.
2. Tilt the treadmill back until it rolls freely on the wheels, and
carefully move the treadmill to the desired location.
Never
move the treadmill without tipping it back. To reduce
the risk of injury, use extreme caution while moving
the treadmill. Do not attempt to move the treadmill
over an uneven surface.
3. Place one foot against one of the wheels, and carefully
lower the treadmill until it is in the storage position.
Latch
Pin
Handrail
Wheel
Frame
Latch
Knob
Catch
