ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver ,
adjustable wrenches , and 9/16” socket wrench .
3. Using two adjustable wrenches, attach the Wheels (15)
to the inside of the Base (71) with the two Wheel Bolts
(14) and the two Nuts (42) as shown (only the right side
is shown). Do not overtighten the Wheel Nuts; the
Wheels should turn freely.
1. Note: To identify
small parts used
during assem-
bly, refer to the
PART IDENTIFI-
CATION CHART
in the center of
this manual.
With the help of a second person, carefully tip the treadmill
onto its left side. Identify the Right Handrail (6), which has
a large hole near the lower end. Hold the Right Handrail in
the position shown. Feed the end of the Wire Harness
(22) into the hole in the lower end of the Right Handrail
and out of the upper end of the Right Handrail. Hold a
Frame Spacer (13) between the Right Handrail and the
Frame. Attach the Right Handrail with a Frame Bolt (10),
a Handrail Washer (11), and a Star Washer (33).
Tip the treadmill onto its right side and attach the Left
Handrail (not shown) as described above. Note: There
will not be a wire harness in the Left Handrail.
1
14
71
42
3
15
33
6
22
Large
Hole
55
13
11
10
Bend
•Hazardous Voltage
•Risk of Electric Shock
•Unplug Treadmill before Assembly
/Disassembly.
2. Hold the Base (71) against the Right Handrail (6) and the
Left Handrail (not shown), with the Base Pads (19) in
the positions shown.
Using a 9/16” socket wrench and the allen wrench, attach
the Base (71) to the Right Handrail (6) with two Handrail
Bolts (12), two Formed Washers (31), and two Nuts (42).
Do not tighten the Nuts yet. Attach the Base to the Left
Handrail (not shown) in the same way. Tighten all four
Nuts. Insert the excess Wire Harness (22) up into the
Right Handrail.
With the help of a second person, raise the treadmill so
the Base (71) is resting flat on the floor.
42
6
31
22
71
19
12
19
2
5
