66
5
38
7
7. Attach the Storage Latch (66) to the left Upright (38)
with two 3/4” Screws (5).
8.
Make sure that all parts used in assembly are properly tightened before you use the treadmill.
Keep
the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page
13). To protect the floor or carpet, place a mat under the treadmill.
87
No
Screw
53
10
5
4
5
5
5
5
6
6. Set the Console (11) in the Console Base (87).
Make sure
that no wires are pinched
. Insert as much of the Wire
Harness (53) as possible down into the hole in the right
Handrail (4).
Securely tighten the plastic tie nearest to
the right Handrail.
Pull any excess Wire Harness
between the plastic ties tight and tighten the other plastic
tie. Cut off the ends of the plastic ties. Cover the Wire
Harness with the Wire Cover (10), and route the Wire
Harness out of the hole in the side of the Wire Cover.
Attach the Wire Cover to the back of the Console Base
with two 3/4” Screws (5).
Do not overtighten the Screws.
Make sure that no wires are pinched before you
attach the Console (11) to the Console Base (87).
Tighten five 3/4” Screws (5) into the Console Base and
the Console in the locations shown.
Note: No 3/4”
Screw goes into the hole indicated by the arrow. Do
not overtighten the Screws.
7
11
Ties
