7
9. While another person holds the Handlebar (15) near
the Upright (13), connect the console wire to the
Extension Wire (36). Next, attach the Handlebar to the
Upright with two M8 x 15mm Screws (34) and two M8
Split Washers (42). Be careful to avoid pinching the
console wire and the Extension Wire.
9
10
45
1
34
42
42
43
34
42
15
36
Console
Wire
13
13
19
36
10. While another person holds the Upright (13) in the
position shown, connect the Extension Wire (36) to
the Reed Switch Wire (43). Next, connect the
Resistance Cable (19) to the Lower Cable (45) in the
following way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (45), and insert the tip of the
Resistance Cable (19) into the wire clip inside the
metal bracket as shown.
• See drawing B. Firmly pull up the Resistance Cable
(19) and slide it into the top of the metal bracket as
shown.
• See drawing C. Using pliers, squeeze the prongs on
the upper end of the metal bracket together.
Push the excess wire and cable down into the Frame
(1), and slide the Upright (13) onto the Frame. Be care-
ful to avoid pinching the wires and cables. Attach
the Upright with two M8 x 15mm Screws (34) and two
M8 Split Washers (42).
A
B
C
45
19
19
Metal
Bracket
Metal
Bracket
45
16
Hole
Ground
Wire
Batteries
49
16
8
8. The Console (16) requires three AA batteries (not
included); alkaline batteries are recommended. Insert
three batteries into the Console as shown in the inset
drawing. Make sure that the batteries are oriented
as shown by the markings inside the Console.
While another person holds the Console (16), attach
the ground wire to the Handlebar (15) with an M4 x
12mm Screw (25). Next, insert the excess ground wire
into the Console, and insert the console wire down
through the indicated hole in the Handlebar.
Attach the Console (16) to the Handlebar (15) with
four M4 x 16mm Screws (49). Be careful to avoid
pinching the ground wire and the console wire.
25
Console
Wire
15
