Wesco WS8043, Инструкция по эксплуатации, Страница: 13 / 16

13
EN
3. TO REPLACE THE BRUSHES (SEE FIG.
D1
-
D3)
WARNING: Remove the plug from the
socket before carrying out any
adjustment, servicing or maintenance.
Unscrew the carbon brush cap with screwdriver.
Remove the carbon brush. Check the length of the brush
and replace if under 6mm. When brushes need replacement
always renew both brushes, even if one is still more than
6mm long.
NOTE:
please call helpline to purchase new brushes.
Continuing to use the tool when carbon brushes need to be
replaced may cause permanent damage to the tool.
MAINTENANCE
1. Store the tool, instruction manual and accessories in
a secure, dry place. In this way you will always have the
information ready.
2. Keep the tool’s air vents unclogged and clean at all times.
3. Remove dust and dirt regularly. Cleaning is best done
with a rag or brush.
4. Never use caustic agents to clean plastic parts.
CAUTION: Do not use cleaning agents to
clean the plastic parts of the tool. A mild
detergent on a damp cloth is recommended.
Water must never come into contact with the
tool.
TROUBLESHOOTING
Problem Possible cause Fault correction
Device does not start
Mains voltage is not present
Check plug socket, cable, line, plug and fuse, where
appropriate, repair through electrical specialist
Defective on/off switch
Repair through customer service Worn carbon brushes
Defective motor
Device works with
interruptions
Damaged power cable Check cable, replace it
Internal loose connection
Repair through customer service
Defective on/off switch