Wesco WS2539, Руководство пользователя

Страница: 31 / 36

31
EN
OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY PACK
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet,
the green light will illuminate.
2) Push the battery pack into the charger,
the red light will illuminate to indicate that
charging has started.
3) When charging has completed, the green
light will illuminate. The battery is now fully
charged. Unplug the charger and remove the
battery pack.
WARNING:
When battery charge runs out
after continuously use or exposure
to direct sunlight or heat, allow time
for the tool to cool down before re-
charging to achieve the full charge.
CHARGER INDICATOR
Light Status
Red on
Charging
Green on
Fully Charged
B) TO REMOVE OR INSTALL BATTERY
PACK (SEE FIG. A1, A2)
Depress the Battery Pack Release Button to
release and slide the Battery Pack out from your
tool. After recharge, Slide it back into your tool. A
simple push and slight pressure will be sufficient.
ASSEMBLY
WARNING: Always turn off mini drill
before changing accessories, changing
collets, or servicing the tool.
1. FITTING AN ACCESSORY (SEE B)
Keep the spindle lock button depressed. Use the
spanner to slacken the collet nut. Then insert the
shaft of the accessory into the collet nut.
Use the spanner to lightly tighten the collet nut
(do not over tighten).
WARNING:
Do not engage the spindle
lock button while mini drill is running.
2. REPLACING THE COLLET (SEE C)
When using an accessory with a smaller or larger
shaft, i.e.: drills, you will need to change the
collet as detailed below:
Keep the spindle lock button depressed. Use the
spanner to slacken the collet nut. Then remove
the collet nut and old collet and locate the new
collet. Afterwards restore the collet nut. Finally
release the spindle lock button.
Caution: Always use the collet which matches the
shank size of the accessory you plan to use. Do
not force a larger diameter shank into a smaller
collet.
3. FITTING A CUTTING/SANDING
WHEEL (SEE FIG D, E)
Use the cutting wheel fixture (13).
First locate mandrel as detailed earlier. Then
unscrew small screw on top of wheel fixture.
Insert screw through wheel and screw into
mandre. Do not over tighten, otherwise the wheel
may crack.
Caution: Always hold the tool away from your
face. Accessories can be damaged during
handling and can fly apart as they come up to
speed.