Wesco CSC165W, Быстрый старт

Страница: 11 / 16

11
EN
TECHNICAL DATA
Type WS2316U(CSC165W) (23-designation of
machinery, representative of circular saw)
Voltage 20V Max**
No load speed 4000/min
Blade size 6-1/2”(165mm)
Cutting capacity 90° 2-5/64”(53mm)
45° 1-27/64”(36mm)
Bevel capacity 0-45°
Charger protection class
/ II
Charger input (WS9924U) 120V~60Hz 55W
Charger output (WS9924U) 20V 2.0A
Battery pack (WS9940)
4.0 Ah Li-ion
**Voltage measured without workload. Initial battery voltage
reaches maximum of 20 volts. Nominal voltage is 18 volts.
ACCESSORIES
Allen key 1
parallel guide 1
40T saw blade 1
24T saw blade 1
Battery pack (WS9940) 1
Charger (WS9924U) 1
We recommend that you purchase your accessories listed
in the above list from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
The machine is intended for use around the
home and domestic applications. It is particularly useful
for trimming plywood and similar sheet material. It is NOT
suitable for metal cutting blades or discs.
BEFORE OPERATION
1. CHARGING THE BATTERY PACK
a)Do not use any charger other than that specifically
provided for use with the equipment.
b) If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the battery
to cool down before recharging.
c) The battery in your new tool is not charged when it leaves
the plant. Therefore it must be full charged before using the
first time.
d) Please charge the battery to reach full or no less than half
charge before storage. If the tool will not be used for long
periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (SEE FIG. A)
1) Plug the charger into an appropriate outlet. The light will
be green.
2) Slide the battery pack into the charger, the light will turn
to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green.
The pack is now fully charged, unplug the charger and
remove the battery pack.
CHARGING INDICATOR
This charger is designed to detect some problems that can
arise with battery packs. Indicator lights indicate problems
(see table below). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new battery
charges correctly, then the original pack is defective and
should be returned to a service center or recycling service
center. If the new battery pack displays the same problem
as the original Battery Pack, have the charger tested at an
authorized service center.
Light Status
Red on
Charging
Green on
Fully Charged
WARNING: When battery charge runs out after
continuously use or exposure to direct sunlight
or heat, allow time for the tool to cool down before re-
charging to achieve the full charge.