Page
3
of
19
© Copyright 2019 WESCO Industrial Products, LLC. Specifications subject to change. Not responsible for errors or omissions.
3. OPERATION
1)
Units are designed for working on the flat and even ground.
2)
Handle (102X) is used for pulling and steering.
3)
When the fork is lifted to its highest position, the unit should not be moved.
4)
Push Up-button, the fork goes up. Stop pushing, the fork can stop at any position and won’t slide down.
5) Push Down-Button, the fork goes down. Stop pushing, the fork can stop at any position and won’t slide
down.
6) As a safety valve is set in the pump station, when DGB series lifts a load of 1000kgs (its full capacity),
only mid-cylinder (413) can extend out fully, while the piston rod (406) cannot extract out to prevent
overload.
7)
Recharge Battery (254) when the lifting speed is remarkably slow. There only three red (LBD) lighting in
the electric volume gauge (283). To plug recharger (271) into a power socket. Make sure your local
power matches the recharger. Then connect the recharger to Socket (225) in the electrical control case.
The battery will be automatically recharged. In the meantime the yellow (LBD) lights. Recharging
usually takes 4 to 5 hours.
4. SAFETY INFORMATION
1)
Operator should read all warning labels and instructions before using this truck.
2)
Lifting the fork to its full range 1-2 times before use to release any air in the hydraulic system.
3)
Do not use on sloped surfaces.
4) Do not put your hand or foot under the fork or on the moving surface of piston rod (406) and mid-
cylinder (413).
5)
Do not lift or transport people on the pallet truck.
6)
Do not load goods like fig. 3/B. Center loads on the pallet truck.
7)
The safety valve in the pump station will be automatically open when it is overloaded. Under such
circumstance, don’t push up-button. Otherwise that will reduce the lifetime of the pump station.
8)
To replace or fill hydraulic oil, the forks should be lowed to the lowest position. The oil to be used
should be clean. The oil condensation point should be
≤
- 20ºC. The motion viscosity: 20-30 cst
(centistokes).
Note:
On this product the battery is fastened/tightened down with a bracket. This product should not tip over
if the load or skid is properly or equally positioned on the forks. If the load/skid is half way on the forks,
damage can occur to the scissors or truck. The safety feature with this truck is as a load is being lifted the
scissors feet will become firm with the floor. The truck cannot move forward or reverse.
Figure 3
Electric High Lift Truck
(Part # 272937 & 272939)
Instruction Manual
ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR WESCO HIGH LIFT
TRUCK, READ THESE INSTRUCTIONS ENTIRELY BEFORE USING.
