Page
3
of
7
Folding Handle Scissors Lift Table
(Part # 260201)
Instruction Manual
ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR SCISSORS LIFT TABLE,
READ THESE INSTRUCTIONS ENTIRELY BEFORE USING.
3. DAILY INSPECTION
Daily inspection is effective to find any malfunction or fault on the lift table. Check the lift table for the
following before operation:
1) Check for any scratches, bending or cracking on the lift table.
2) Check if there is any oil leakage from the cylinder.
3) Check the vertical creep of the table.
4) Check the smooth movement of the wheels.
5) Check
the
brake.
6) Check all bolts and nuts are tightened firmly.
CAUTION: Do not use lift table if any malfunction or fault is found.
4. OPERATION
4.1 Braking
CAUTION: Lift the brake when not moving it in order to prevent sudden movement.
The brake is equipped with the swivel caster on the right side.
1) Brake the wheel by pressing the brake pedal.
2) Release the brake by lifting up the brake pedal.
4.2 Lifting
Warning
1) Do not overload lift table. Stay within its rated capacity.
2) Do not side or end. Load must be distributed on at least 80% of table area.
Press the lifting pedal several times until the table reaches the desired position. The table does not
elevate after reaching the highest position even if the lifting pedal is pressed. The table lowers slightly
after reaching the highest position.
Model
LT-330SL
Part Number
260201
Max Capacity (lbs)
330
Note: The hydraulic cylinder is designed to hold the table. The nature of hydraulic systems cause the
table to lower very slowly over an extended period of time. Please note the table does not stay at the
same position indefinitely.
4.3 Lowering
Warning: Do not put foot or hand in scissors mechanism
1) Rotating the knob lowers the table.
5. MAINTENANCE
5.1 Lubricate each point described below every month
5.2 Change hydraulic oil every 12 months.
Lubricating Points
1) Fitting of Cylinder – Oil
2) Roller Friction Surface – Grease
3) Link Pin – Oil
4) Pedal Fitting Point – Oil
5) Grease Nipple - Grease
