P.6
Manipulating the Wireless Digital CCD Camera
Manipulating the Wireless Digital CCD Camera
●
Turn On
●
Turn On
●
Pair
●
Pair
●
Recharge
●
Recharge
Plug in the USB charger here.
Press to turn on the device, after successfully connected with the “Wireless
Digital USB Receiver” (Hereinafter called USB Receiver), Lamp/Setup will then
turn into blue. Once failed to connect or beyond the received range, Lamp/Setup
flashes once 2 seconds. As below fig (Fig 1)
While the “Wireless Digital Security Camera” (Hereinafter called Camera) is
under the standby mode, press Lamp/Setup and last for 4 seconds, Lamp/Setup
will then continuously flash in blue. Meanwhile, click the pairing button on the PC
screen to process pairing. After Camera was successfully paired with USB
Receiver, Lamp/Setup will steadily keep in blue, and images from that camera
will be displayed simultaneously on the pc screen. Once Camera was failed to be
paired with USB Receiver, Lamp/Setup flashes once 2 seconds. Users may
follow the described steps to make pairs again. As below fig (Fig 1)
While
turns into yellow, it means the Camera is running out of battery. Users
may now plug in the USB charger, and
will turn into red during recharging
.
The Camera should be recharged for 3 hours before first-time used, and should
be recharged for 1 hour when the battery is low.
On / Off
P
o
w
e
r 5
V
Blue Pairing
Red Charge
Green Low Battery
Lamp/Setup
Antenna
Digital Wireless Camera
WS-CAMERA-CCD1
WENSHING
Confidential
Do
Not
Distribution
