7
C
OVER
P
ANEL
I
NSTALLATION
C
ONTINUED
1/4-20 x 2.359
Machine Screw
Plug
Drill
Hole
Plug
Drill
Hole
Note: Cabinet shelves are
not shown for clarity.
1/4-20 x 2.359
Machine Screw
C
ENTER
C
OVER
P
ANEL
I
NSTALLATION
Use the following steps ONLY when a smaller cabinet is adjacent to a larger cabinet
with a cover panel in place on the larger cabinet.
1. Install the Cover Panel using the procedures in “End Cover Panel Installation” on page 4.
2. Align both cabinets to the desired configuration.
If the cabinets are different depths, they may be aligned to be
flush with the front as shown or flush with the back.
NOTE:
Do not drill into a shelf or cross member.
Measure before drilling so that the hole is
1-2” from the nearest horizontal surface to
allow clearance for tools. It may be necessary
to move a hole and drill completely through the
smaller cabinet side panel, cover panel and
larger cabinet side panel simultaneously.
3. Drill two connecting holes through the
Cover Panel and attached cabinet side panel
(drill three holes if the cabinets are both
over 68” tall) using the 3/8” drill bit through
the holes already in the smaller cabinet.
4. If there is not enough room in the compartment
for a drill, it may be necessary to mark the holes
using a pencil through the connecting holes in the
smaller cabinet side panel, move the smaller
cabinet, drill the holes through the Cover Panel
and larger cabinet side panel, re-position the
smaller cabinet and connect them all together.
4. Connect the cabinets together using
1/4-20 x 2.359 Machine Screws.
5. Plug the hole at the other end with the Plugs
that were included with the cabinet.
6. Use of Filler Strips between the smaller cabinet
and the Cover Panel is required
(filler strips are included with cabinet).
