Wenger Showmobile Mobile Stage and Canopy, Руководство пользователя

Страница: 26 / 36

26
To avoid personal injury, use only
authorized and trained personnel.
!
CAUTION
Use tie-downs to secure all
equipment in Showmobile
!
CAUTION
Closing the Showmobile for Travel
Clear the Stage
Remove all equipment, and sweep all dirt, grit, and
other debris from the stage�
Disconnect the Auxiliary Power
Disconnect the extension cord for the auxiliary
electrical system�
Load Auxiliary Equipment
Load supplementary equipment such as lighting,
sound systems, generator systems, chairs, etc�,
into the Showmobile�
Important: Allow enough clearance for the hydraulic
stage floor when it is folded up into its storage
position�
Remove the Stairway(s)
Remove the stairways from their set position� Store
them inside the Showmobile�
Load any Stage Extensions
Disconnect any auxiliary stage units from the stage
floor. Store these units inside the Showmobile.
Be sure to remove the connectors from the channels
around the edge of the stage�
To provide proper weight distribution for towing, store
the stage extensions and any other cargo in the front
one-third of the Showmobile�
Secure the Equipment Inside the Unit
Secure all equipment inside the Showmobile so that
it will not shift during transport� Shifting could cause
damage and create a dangerous distribution of cargo
weight. Tie-downs are located along the stage floor
inside the Showmobile� Locate cargo near these tie-
downs, and securely tighten the tie-down straps which
are provided� Do not exceed the 16,000 lb gross
vehicle weight rating�
Lower the Roof/Canopy to the
Intermediate Position
If the Showmobile is equipped with an optional lighting
package, the canopy will need to be lowered for
accessibility to fold up the lighting fixtures.
Set the roof/canopy switch at lower to lower the roof/
canopy partway down�
Leave enough clearance for raising the hydraulic
stage�
Raise the Hydraulic Stage
Move the flip-down panels upward to the storage
position�
1� Lift the panel slightly and move the leg upward to
the magnetic latch�
2� Lift the panel and lower it onto the main hydraulic
stage�
3� Latch the panel in place by placing the hook
into the panel groove and then rotating the latch
handle until it stops against the hook�
4. Repeat step 1, 2, and 3 for the other flip-down
panels�
Set the stage switch on the remote control to raise,
until the hydraulic stage is in its vertical storage
position� Return the legs to their original length
position to avoid damage if there is an uneven surface
when the stage is used next time� Check that the legs
swing against their retaining magnets�
Lower the Roof/Canopy
If the Showmobile is equipped with an optional lighting
package, watch and verify that nothing will contact the
lighting fixtures while closing.
Set the roof/canopy switch on the remote control to
lower, until the canopy leading edge fully contacts the
roadside fender skirting�
Close the End Panels
Lift the end flaps. Unpin the end panel positioning
braces, and lift and latch them against the vertical
column structure� Close and lock the end panels�
Never lower the roof with people inside
the Showmobile or under the roof.
!
CAUTION