6
A
SSEMBLY
(
CONTINUED
)
5. Place the Seat Assembly (7) over the top of the Gas Cylinder.
Rotate it as needed to align the three extruded profiles on the shaft of the
Gas Cylinder with the squared-off notches without screws.
Press the Seat Assembly onto the top of
the Gas Cylinder.
6. Slide the top of the Telescoping Cover (6)
up and snap it onto the bottom of the
Seat Adapter
7. Position the Foot Rest to be located under the front side of the
Seat Assembly and tighten the Foot Rest Adjustment Knob.
8. Keeping the Gas Cylinder at the lowest position,
carefully
sit on the chair to apply additional pressure
to fully engage the components.
To check that all of the components are fully engaged,
hold onto the Seat Assembly and lift the chair.
The chair should remain assembled.
The Seat Height Adjustment Lever can be
used to adjust the Seat Assembly to a
higher position.
9. Press the Stop Release Button and insert the
post of the Back Rest (8) into the opening
at the back of the Seat Assembly.
Release the Back Height Adjustment Lever to allow
the post to completely slide through the opening.
Back
Rest
(8)
Back Height
Adjustment
Lever
Stop
Release
Button
Seat
Assembly
(7)
Top of
Gas Cylinder
Seat Height
Adjustment
Lever
Align the
Extruded Profiles with the
Squared-Off Notches
Top of
Telescoping
Cover
(6)
Bottom of
Seat Adapter
Seat Assembly not
shown for clarity.
Содержание Nota
Страница 7: ...7 OPERATION ...
Страница 8: ...8 OPERATION CONTINUED ...
