2
Important User Information
General
Copyright © 2022 by Wenger Corporation
All rights reserved. No part of the contents of this manual may be reproduced, copied, or transmitted in any form or
by any means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage
and retrieval systems without the written permission of the publisher, unless it is for the purchaser's personal use.
Printed and bound in the United States of America.
The information in this manual is subject to change without notice and does not represent a commitment on the part of
Wenger Corporation. Wenger Corporation does not assume any responsibility for any errors that may appear in these
instructions.
In no event will Wenger Corporation be liable for technical or editorial omissions made herein, nor for direct, indirect,
special, incidental, or consequential damages resulting from the use or defect of these instructions.
The manufacturer reserves the right to change this product at any time.
The information in this document is not intended to cover all possible conditions and situations that might occur.
The end user must exercise caution and common sense when assembling or installing Wenger Corporation products.
If any questions or problems arise, call the Wenger Corporation at (800) 4WENGER (493-6437) or +1-507-455-4100
worldwide.
Manufacturer
The Director's Stand is manufactured by:
Wenger Corporation
555 Park Drive
Owatonna, MN 55060
(800) 4WENGER (493-6437) • +1 (507) 455-4100
wengercorp.com
Intended Use
• This product is intended for indoor use in normal ambient temperature and humidity conditions —
it must not be exposed to prolonged outside weather conditions.
• This product is intended to be assembled and used only as described in these instructions.
Warranty
This product is guaranteed free of defects in materials and workmanship for five full years from date of shipment.
A full warranty statement is available upon request.
The following tools are required for assembly.
• 5/32" Hex wrench
• Two 7/16" open-end wrenches
• 9/16" Open-end wrench
• Phillips screwdriver
Required Tools