PREPARATION
CONNECTING GARDEN HOSE TO PRESSURE WASHER
(FIG. 8)
1. Run water through the hose for a few seconds to flush
any debris from the hose.
2. Inspect water inlet screen (Fig. 8 - 2) and remove any
debris.
3. Connect hose (Fig. 8 - 1) to water inlet (Fig. 8 - 2) and
tighten by hand. There must be a minimum of 10 feet of
unrestricted hose between pressure washer and faucet or
shut off valve.
4. Turn on water.
5. Purge the system’s pump of air by releasing the safety
and squeezing the trigger of the spray gun.
CONNECT HIGH PRESSURE HOSE TO PUMP (FIG. 9)
1. Attach the end of high pressure hose (Fig. 9 - 1) to the
high pressure outlet (Fig. 9 - 2) on pump.
2. Follow the same procedure with opposite end to attach
high pressure hose to spray wand.
OPERATION
DANGER:
CARBON MONOXIDE. Using a pressure washer indoors CAN KILL YOU IN MINUTES.
Pressure washer exhaust contains carbon monoxide (CO). This is a poison gas you cannot see or
smell. If you can smell the pressure washer exhaust, you are breathing CO. Even if you cannot
smell the exhaust, you may be breathing CO.
NEVER use a pressure washer inside homes, garages, crawlspaces, or other partly enclosed areas.
Deadly levels of carbon monoxide can build up in these areas. Using a fan or opening windows and
doors does NOT supply enough fresh air.
ONLY use a pressure washer outside and far away from windows, doors, and vents. These openings
can pull in pressure washer exhaust. Even if you use a pressure washer correctly, CO may leak into
the home. ALWAYS use a battery-powered or battery-backup CO alarm in the home.
If you start to feel sick, dizzy, or weak after the pressure washer has been running, move to fresh air
RIGHT AWAY. See a doctor. You may have carbon monoxide poisoning.
Fig. 8
Fig. 9
1
2
1
2
14
WARNING:
The intake water temperature must not exceed 104°F (40°C). The water supply
must not exceed 101 PSI (700 kPa).