15
14
ASSEMBLY & ADJUSTMENTS
WARNING:
Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read
through and become familiarized with the following procedures of handling and adjusting your miter saw. Failure
to follow the safety instructions may result in serious personal injury.
INSTALLING THE SUPPORT STAND
The support stand offers additional stability for your
miter saw. Follow the instructions below to install the
support stand.
1. Locate the two holes for the support stand on the back
of the miter saw (Fig. 6 - arrows). Loosen the Phillips-
head screw on the bottom of the left hole (Fig. 6 - 2),
then insert the support stand (Fig. 6 - 1) into the holes.
2. Secure the stand into place by tightening the stand
lock screw (Fig. 6 - 1). See p. 11 - X for installation ori-
entation.
BENCH MOUNTING
1. The miter saw base has four holes on the base for
bench mounting (Fig. 7 - arrows). Mount and fix the
saw to a level, horizontal bench, worktable, or miter
saw stand (compatible with WEN Models MSA330 and
MSA750) using four bolts and nuts (not included).
2. If desired, you can mount the saw to a piece of 1/2"
or thicker plywood which can then be clamped to your
work bench or moved to other job sites and reclamped.
CAUTION:
Make sure that the mounting surface is not
warped. Uneven surfaces can cause binding and inac-
curate sawing.
INSTALLING THE DUST COLLECTION BAG
The dust collection bag should be used at all times. Fol-
low the instructions below to install the bag.
1. Locate the dust port on the back of the miter saw (Fig.
8 - arrow).
2. Squeeze the metal clip on the dust collection bag to
open the mouth of the bag. Slip the mouth of the dust
collection bag over the dust port and release the clip to
secure the bag to the outlet.
3. Open the zipper on the bottom of the bag to empty.
For efficient operation, empty the dust bag when half full
to allow for better air flow through the bag.
Fig. 6
Back View
18"
17-7/8"
Fig. 7
Fig. 8
1
2