Wen DW6394, Инструкция по эксплуатации

Страница: 12 / 16

12
PROBLEM CAUSE SOLUTION
Motor is not working.
1. Wires in the main plug are loose or
the switch is faulty.
1. Stop using the tool and contact
customer service at 1-(800) 232-1195 ,
M-F 8-5 CST for assistance.
2. Brushes are worn.
2. Check and replace brushes if neces-
sary (p. 11).
Unusual noises occur during
operation. Motor is not
working properly.
1. Switch contact has failed.
1. Stop using the tool and contact
customer service at 1-(800) 232-1195 ,
M-F 8-5 CST for assistance.
2. Components have jammed.
2. Unplug the tool and check that
components can move normally. If it
is found that they can not, stop using
the tool and contact customer service
at 1-(800) 232-1195 , M-F 8-5 CST for
assistance.
3. Too high of load has been applied.
3. Use less pressure during sanding
operations.
Motor gets excessively hot.
1. Foreign substances have gotten
inside the motor.
1. Unplug the unit and inspect for for-
eign substances. Remove any foreign
substances if found.
2. Too high of load has been applied.
2. Let the unit rest for a few minutes
and use less pressure during sanding
operations.
Frequent sparks occur on the
commutator.
1. There is a short circuit in the motor
(armature).
1. Have the armature replaced.
2. Carbon brushes are worn out or
jammed.
2. Replace the carbon brushes as
described on page 11.
NOTE: Carbon brush life depends on the amount of load being taken on by the motor. Regularly
inspect the brushes after 50 hours of use.
TROUBLESHOOTING GUIDE
WARNING! Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by an authorized technician. For any questions, please contact our customer
service at 1-(800) 232-1195 , M-F 8-5 CST or email us at techsupport@wenproducts.com.