UNPACKING
With the help of a friend or trustworthy foe, carefully remove the bench grinder from the packaging. Make sure to
take out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing
list below to make sure you have all of the parts and accessories. If any part is missing or broken, please contact
our customer service at
1-800-232-1195
(M-F 8-5 CST), or email
.
PACKING LIST
UNPACKING & TRANSPORTATION
WARNING!
Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
TRANSPORTING
When transporting the bench grinder, carry it by the base. Never carry the tool by its guards or its accessories.
8
AMPERAGE
REQUIRED GAUGE FOR EXTENSION CORDS
25 ft.
50 ft.
100 ft.
150 ft.
2.1A
18 gauge
16 gauge
16 gauge
14 gauge
1.
Examine extension cord before use.
Make sure your extension cord is properly wired and in good condition.
Always replace a damaged extension cord or have it repaired by a qualified person before using it.
2.
Do not abuse extension cord.
Do not pull on cord to disconnect from receptacle; always disconnect by pulling
on plug. Disconnect the extension cord from the receptacle before disconnecting the product from the extension
cord. Protect your extension cords from sharp objects, excessive heat and damp/wet areas.
3.
Use a separate electrical circuit for your tool.
This circuit must not be less than a 12-gauge wire and should
be protected with a 15A time-delayed fuse. Before connecting the motor to the power line, make sure the switch
is in the OFF position and the electric current is rated the same as the current stamped on the motor nameplate.
Running at a lower voltage will damage the motor.
GUIDELINES AND RECOMMENDATIONS FOR EXTENSION CORDS
When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The table below shows
the correct size to be used according to cord length and ampere rating. When in doubt, use a heavier cord. The
smaller the gauge number, the heavier the cord.
ELECTRICAL INFORMATION
Bench
Grinder (1)
Eye Shield
Assembly (2)
Tool Rest Knob (2)
Spark Deflector
Screw Assembly (2)
Lock Washer (2)
Carriage Head Tool
Rest Screw (2)
Tool Rest (2)
Spark Deflector
(2)
Eye Shield
Arm (2)
Hex Bolt M6x30 (2)
Flat Washer (2)
Содержание BG4266
Страница 15: ...15 EXPLODED VIEW PARTS LIST 15...
Страница 18: ...18 NOTES...
Страница 19: ...19 NOTES...
Страница 20: ...THANKS FOR REMEMBERING v 2019 09 06...