ASSEMBLY & ADJUSTMENTS
11
ASSEMBLING THE METAL BAND SAW
1. Attach the four feet (Fig. 2 - 1) to each respective corner
of the base.
2. Place the machine on a work bench, and secure it in
place by using the three holes provided in the base (Fig.
3). Use appropriate mounting hardware (not included). The
holes are 8.5mm (0.335") in diameter.
3. Screw the guide rail into the threaded hole on the vise
base. Use an adjustable wrench (not included) to turn the
hex nut and secure the guide rail in place.
4. Attach the work stop (Fig. 2 - 2) to the guide rail (Fig.
2 - 3). Secure it in place by tightening the locking handle.
NOTE:
The locking handle is spring-loaded and can be re-
positioned as need be. To re-position the handle, pull it out-
wards, turn it to the desired position, and release it.
POSITIONING THE WORK STOP
If you have to make a series of cuts with a uniform length,
use the supplied work stop.
1. Loosen the lock handle (Fig. 4 - 1).
2. Slide the work stop to the desired distance.
3. Tighten the lock handle again.
WARNING!
Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read
through and become familiarized with the following procedures of handling and adjusting your tool. Failure to
follow the safety instructions may result in serious personal injury.
Fig. 2
1
1
2
3
Fig. 3
WARNING!
Make sure that the work stop does not
interfere with the downward movement of the blade.
Fig. 4
1
Содержание BA4555
Страница 16: ...EXPLODED VIEW PARTS LIST 16 ...
