Wen 6508, Руководство пользователя

Страница: 5 / 18

5
SPECIFIC RULES FOR THE BELT/DISC SANDER
10. Do not sand pieces of material that are too small to be safely supported.
11. When sanding a large workpiece, provide additional table height support.
12. Do not sand with the workpiece unsupported. Support the workpiece with the table. The only exception is
curved work performed on the outer sanding drum.
13. Always remove scrap pieces and other objects from the table, or belt before turning the sander ON.
14. Never perform layout, assembly or set-up work on the table while the sander is operating.
15. Never use solvents to clean plastic parts. Solvents could dissolve or otherwise damage the material. Use only a
soft damp cloth to clean plastic parts.
16. Should any component of your sander be missing/damaged or fail in any way, shut off switch and remove plug
from power supply outlet. Replace the missing, damaged, or failed parts before resuming operation.
17. Never pull the power cord out of the receptacle. Keep cords away from heat, oil, and sharp edges.
18. Have an electrician replace or repair damaged or worn cords immediately.
CALIFORNIA PROPOSITION 65 WARNING
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities
may contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other re-
productive harm. Wash hands after handling.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks, cement, and other masonry products.
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies depending on how often you do this type of work. To reduce your exposure
to these chemicals, work in a well-ventilated area with approved safety equipment such as dust masks specially de-
signed to filter out microscopic particles.