Wen 6321, Руководство пользователя, Страница: 9 / 12

9
OPERATION
Hold the tool firmly with both hands. Turn the switch on and permit the
rotation of the abrasive belt to reach full speed.
Then gently place the tool on the work piece surface. Move the tool back
and forth. Never exert excessive pressure on the tool. The weight of the
tool applies adequate pressure. Excessive pressure will retard the abrasive
action, leave an uneven finish and cause extra wear to both the tool and the
abrasive belt.
Always lift the tool off the work piece before turning the switch off.
MAINTENANCE
SERVICE:
Preventive maintenance performed by unauthorized personnel may result in misplacing of internal
wires and components, possibly causing a serious hazard. We recommend that all tool service be performed by an
authorized WEN service station.
TOOL LUBRICATION
: Your tool has been properly lubricated and is ready to use. It is recommended that
tools with gears be regreased with a special gear lubricant at every brush change.
CARBON BRUSHES
: The brushes in your tool have been engineered for many hours of dependable service.
To maintain peak efficiency of the motor, we recommend examining the brushes every two to six months. Only
genuine WEN replacement brushes designed specifically for your tool should be used.
CLEANING:
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not at-
tempt to clean these components by inserting pointed objects through openings.
WARNING
: To avoid accidents, always disconnect the tool from the power supply before cleaning
or performing any maintenance. The tool may be cleaned most effectively with compressed dry air.
Always wear safety goggles when cleaning tools with compressed air.
WARNING:
Certain cleaning agents and solvents damage plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain
ammonia.