Wen 61741, Руководство пользователя, Страница: 10 / 16

10
OPERATION
WARNING: Never uninstall or install the
flooring shoe while the nailer/stapler is
attached to its air supply or while nails are
loaded in the magazine.
REMOVING THE FLOORING SHOE
For general installation at a 90-degree angle, use
the following directions to uninstall the flooring
shoe.
1. Open the plate pressing latch (Fig. 6).
2. Open the D-ring pin by unclasping the hook
(Fig. 7 - A) from the pin.
3. Remove the pin from the floor shoe (Fig. 7 - B).
4. Slide the flooring component off (Fig. 8).
5. Close the plate pressing latch (Fig. 9).
INSTALLING THE FLOORING SHOE
1. Open the plate pressing latch (Fig. 9).
Fig. 10
Fig. 11
Fig. 12
Fig. 6
A
B
Fig. 9 Fig. 8
Fig. 7
2. Attach the flooring shoe in place by sliding in the pin.
Reattach the hook to the end of the pin (Fig. 7 -- A).
3. Close the plate pressing latch (Fig. 6).
USING THE FLOORING SHOE
1. Make sure the no-mar tip has been removed from the
nailer.
2. Turn the depth adjustment wheel (Fig. 4) to set the
depth of the fired nail. For flooring, it is suggested to al-
ways fire at the deepest depth.
2. Loosen the shoe adjusting knobs on either side of the
shoe (Fig. 10) so that the flooring shoe adjusts to meet the
needs of the contact piece.
3. Place the contact piece on top of the hardwood flooring.
Push the nailer towards the hardwood (Fig. 11).
4. Place the nose tip flush with the corner tongue of the
hardwood flooring. Once you are sure that the contact
piece is flush with the hardwood, fasten the adjusting knobs
in place.
5. Pull the trigger so that the fastener is fired at an angle
through the hardwood and into the ground (Fig. 12).