10
OPERATION
Work Piece and Work Area Set Up
1.
Designate a work area that is clean and well-lit. The work area must not allow access
by children or pets to prevent injury and distraction.
2.
Route the Power Cord along a safe route to reach the work area without creating a
tripping hazard or exposing the Power Cord to possible damage. The Power Cord
must reach the work area with enough extra length to allow free movement while
working.
3.
Secure loose work pieces using a vise or clamps (not included) to prevent movement
while working.
General Operating Instructions
1.
The tool works by oscillating rapidly. Do not force the tool. Allow the tool to cut or
do its job.
2.
Attachments may be mounted at angles up to 90° left or
right. The attachment should not turn on the spindle. If it
does, make sure that the cap screw is tight. Note: The long
Saw Blade should only be used in the straight ahead
position. (Figure 2)
3.
Retract the Power Switch to its off position. Then connect
the tool into the nearest 120 volt, grounded electrical outlet.
4.
To turn on the tool, slide the Power Switch forward.
5.
Adjust the speed of the tool using the Speed Dial. There are
six speed divisions from 1 (slowest) to 6 (fastest).
6.
Do not allow contact between the Sanding Paper, Scraper Blade, or Saw Blade and
work piece until the tool is running at full speed.
7.
Avoid contact with foreign objects such as metal screws and nails when sanding,
scraping, or cutting.
8.
Do not apply excessive pressure on the tool.
9.
When finished, turn off the tool and allow it to completely stop before setting it down.
Then unplug the tool from its electrical outlet.
10.
To replace the sanding paper, simply pull it off the pad. Prior to storing the tool,
remove the attachment and wipe it clean. Store the Tool in a clean, dry, safe location
out of reach of children and other unauthorized persons.
