Wen 20625, Инструкция по эксплуатации

Страница: 18 / 24

MAINTENANCE
REPLACING THE SAW BLADE
The quality of the cut depends on the condition of the saw blade. Never use a dull, rusty, or damaged blade. Before
operation, check the blade and replace if the blade is worn-out or damaged.
Use circular saw blades with 6-1/2-inch diameter and 20mm arbor size. Do not use a blade that does not match the
diameter or arbor of the saw. Do not use a blade that is too thick; this will prevent the arbor bolt from securing the
blade on the arbor. Do not use a blade thicker than 1.2mm (0.045 inch). Replacement saw blades (Model 20625B)
can be ordered from wenproducts.com. Note that parts that wear down over the course of normal use (like saw
blades, carbon brushes, etc.) are not covered by the two-year warranty.
WARNING! To avoid injury from accidental startups, be sure that the tool is switched off and disconnected
from the power supply before inspecting the unit, making adjustments or changing accessories.
WARNING! Wear safety gloves when handling saw blades to prevent injuries from accidentally contacting
the sharp blade tip.
1. Unplug your circular saw from the power source.
2. Press down the spindle lock to prevent the blade from spinning.
3. Using the included 5mm hex wrench, remove the arbor bolt by turning it clockwise (the bolt is left-hand threaded).
4. Remove the washer and outer flange washer.
5. Lift the lower guard and remove the existing blade.
6. Lift the lower guard and slide the new saw blade onto the spindle. Make sure the arrows printed on the blade
match the direction of the arrows shown on the upper blade guard, and the blade teeth are pointing up.
7. Replace the outer flange washer.
8. Press the spindle lock and replace the arbor bolt and washer. Tighten the arbor bolt securely by turning it coun-
terclockwise with the wrench while holding the spindle lock.
9. Check to make sure the blade is properly installed and spins freely inside the housing. Check that the arbor screw
is tightened and the blade does not wobble while spinning.
18